Dark mode
USA
Catalog   /   Computing   /   Components   /   Graphics Cards   /   INNO3D

INNO3D GeForce RTX 3050 6GB TWIN X2 (N30502-06D6-1711VA60)

Photos - Graphics Card INNO3D GeForce RTX 3050 6GB TWIN X2
Photos 3
INNO3D GeForce RTX 3050 6GB TWIN X2
Main
InterfacePCI-E v4.0
GPU
GPU modelNVIDIA GeForce RTX 3050
ArchitectureAmpere
Memory size6 GB
Memory typeGDDR6
Memory bus96 bit
GPU clock speed1470 MHz
Memory clock14000 MHz
Lithography8 nm
Max. resolution7680x4320 px
Passmark G3D Mark10553 score(s)
Connections
DVI-D1
HDMI1
HDMI versionv.2.1
DisplayPort1
DisplayPort versionv.1.4a
Software
DirectX12 Ultimate
OpenGL4.6
VR
Stream processors2304
General
Monitors connection3
Coolingactive (fan)
Fans2
Minimum PSU recommendation450 W
Number of slots2
Length222 mm
Official Websiteinno3d.com
Added to E-Catalogfebruary 2024
P/N
N30502-06D6-1711VA60

An inexpensive video accelerator of moderate dimensions, built on the basis of the NVIDIA Ampere microarchitecture with 6 GB of video memory and support for DLSS 2 image scaling technology. It is a solution for gamers seeking access to modern graphics technologies at a reasonable cost. It is positioned by the manufacturer as an ideal replacement for the still popular, but still outdated NVIDIA video cards from the 1000, 1500 and 2000 series.

INNO3D GeForce RTX 3050 6GB TWIN X2 is based on the GA106 graphics chip, which has 2304 stream processors on board. The GPU frequency in Boost mode is 1470 MHz, and in general its capabilities are suitable for most modern games at a resolution of 1080p at medium or low graphics settings. The modification in the INNO3D TWIN X2 version has compact dimensions (length 222 mm, thickness 2 slots) and is suitable for installation in small form factor cases. In addition, the card is equipped with DVI-D, HDMI 2.1 and DisplayPort 1.4a ports, which provide the ability to connect both fairly old and modern monitors with high resolution and high refresh rate. The average power consumption of the model is 130 W, and to power the entire system, the manufacturer recommends using a mid-range power supply with a capacity of about 450 W.

Information in model description is for reference purposes.
Before buying always check characteristics and configuration of product with online store manager
Catalog INNO3D 2025 - new products, best sales and most actual models INNO3D.

Good radiator

Inno3D RTX 3050 Twin X2 6GB is perhaps the most successful modification of the RTX 3050 among all six-gigabyte models. Most competitors are either low-profile, single-fan, or have two fans but a small radiator. Whereas the Inno3D has a radiator of almost the entire length of 22 cm. There are no copper tubes, but such a cold video card does not require them.

Digital interface

Video outputs are represented by a trinity of digital ones: HDMI, Display Port and DVI. Moreover, this is DVI-D without the ability to output an analog VGA video signal; now it is supported only by iGPUs. There is no power connector, there is enough power from the PCI-Express 4.0 x8 slot, which sets the RTX 3050 apart from the Radeon RX 6500 XT and Intel Arc A380, both of which require a 6-pin.

Reference frequencies

Twin X2 fans stop completely at low loads, reducing noise and wear to zero. Using the Inno3D TuneIT application, you can manually adjust the speed and frequency. But there is no particular point in overclocking due to the strict power limit of 70 W. Therefore, there is not a single OC modification of the RTX 3050-6GB on sale, only with reference frequencies.

Filters
Models
INNO3D (gpu model) 
NVIDIA GeForce GT 710 
NVIDIA GeForce GT 730 
NVIDIA GeForce GT 1030 
NVIDIA GeForce GTX 1650 
NVIDIA GeForce GTX 1660 SUPER 
NVIDIA GeForce RTX 2060 
NVIDIA GeForce RTX 2060 SUPER 
NVIDIA GeForce RTX 3070 
NVIDIA GeForce RTX 3070 Ti 
NVIDIA GeForce RTX 3080 
NVIDIA GeForce RTX 3090 
NVIDIA GeForce RTX 4070 
NVIDIA GeForce RTX 4070 SUPER 
NVIDIA GeForce RTX 4090