Bike Wheels Park Tool

If you are looking to remove that Sun Tour freewheel on your vintage ride, you're looking at the right tool. The Park Tool Freewheel Remover for Sun Tour 2 Notch is constructed of heat-treated tool steel for maximum durability and the 1-inch base has flats to fit in a wrench or vise. The thin wall construction lets the tool easily fit between axle cones and locknuts so you don't have to remove them for backing off the freewheel.

Maybe you just picked up a sweet vintage bike at the swap meet or you're looking to restore an old beauty, you always need the right tool for the job. The Park Tool Freewheel Remover for Sun Tour 4 Notch since 1986 features heat treated tool steel and a 1-inch base to fit a wrench or vise. Thin wall construction allows you to remove the freewheel without touching the cones or locknuts. The 4 notches measure approximately 24mm across and fit all Sun Tour freewheels since Reagan has been in office.

Achieve balanced spoke tension of your Campagnolo Wheelset with the Park Tool Spoke Wrench for Campagnolo Wheel Systems SW-11. This spoke wrench is precision-machined and plated for durability, then vinyl-dipped for adeptness in hand. It's compatible with both 5. 5 and 6-millimeter spoke hex nipples found on common Campagnolo Wheels.

When it's time to adjust the spoke tension of your Shimano wheels, reach for the Park Tool SW-14. 5 Spoke Wrench for Shimano Wheel Systems. This spoke wrench features a double-sided design that fits both 4. 4 and 3. 75-millimeter spoke nipples of Shimano Wheels. It's precision-machined and plated for durability, then dipped in vinyl for grip and dexterity in hand.

Make quick work of removing four-notch freewheels from flip-flop BMX hubs with the Park Tool Freewheel Remover: BMX freewheels with 30x1mm threads. Made from heat-treated alloy tool steel, this remover has a one-inch base to fit your wrench or bench vise, and uses a thin wall construction to get the job done without the removal of cones or locknuts. This particular remover has four notches approximately 25mm across measured inside to inside.

After a hard season of training and racing, your Mavic wheels will need some love. Place your wheels in a truing stand and grab the Park Tool SW-12 Mavic Spoke Wrench to keep them spinning true and tensioned. The smaller end, with seven splines and a 6. 5mm diameter, will fit Mavics R-sys wheels. On the opposite end, the six spline, 9mm wrench, will fit Mavic Fore equipped wheels (most tubeless mountain bike rims, its equivalent to the Mavic M40630 wrench). Steel construction and precise manufacturing ensure positive purchase so you won't strip soft aluminum nipples. The Park Blue vinyl-dipped handle provides comfort as you work your way around the wheel. As with all Park Tools, the Mavic Spoke …

Wheel building is a science. Though sometimes overlooked, proper tension and a true wheel is a sure fire way to get set up for success, and Park Tool is here to help with the Professional Wheel Truing Stand - TS-4. 2. Updated yet again to fit an even wider range of hub, wheel, and tire combinations the TS-4. 2 is built to accommodate and self-center nearly any diameter wheel from 16-to-29in, and paired up with 5+-inch tires. The stand is built to last a lifetime, with both chrome-plated and powder-coated heavy gauge steel, and precision construction. The TS-4 is machined, welded, assembled, and calibrated in the USA, in Park Tool's factory in St Paul, Minnesota, so the highest level of precision …