Vacuum Cleaner Accessories

It's effective and safe on wet and dry messes on all sealed hard floors, so you can mop up spilled water and dog food in the kitchen with just one machine. The microfiber brush roll gently mops tough more→messes off your hard floors and suctions them up into the machine. For best results, BISSELL recommends using this brush roll with our Wood Floor Formula. When you're done cleaning with your CrossWave Cordless Max or BISSELL CrossWave X7, cleaning the Wood Floor Brush Roll is a breeze with the Self-Cleaning Cycle. That cycle spins your brush roll while flushing clean water through the machine, so the brush roll gets rinsed but also spins to dry faster. Remember to replace your brush roll every 6

Clean your hard floors with the Hard Floor Brush for the BISSELL ICONpet Cordless Vacuum Cleaner, Series 2288 & 2746. To remove and replace the brush roll follow these instructions: Turn the machine O more→FF and press the Foot Release Button to disconnect the Motorized Floor Cleaning Foot from the Extension Wand. With a flathead screwdriver or coin, twist the slot on the side of the foot clockwise and pull the Brush Roll out. To replace, push the Brush Roll back in the chamber and twist counter-clockwise with a tool or coin to lock in place. | Hard Floor Brush Roll ICONpet | 1620762

Hose for the 1154 Series | Hard Floor Expert Canister Vacuum Hose | 1602330

2-Pack of Hard Floor Expert Fluffy Soft Pads for Select BISSELL Robotic Vacuums, including the BISSELL SpinWave Wet and Dry Robotic Vacuum, Series 2859, 3115. To maintain the Mop Pads and Debris Trap, more→follow these instructions. Turn the Power Switch OFF. Press the button on top of the Mop Tank and pull to remove. Place tank upside down on a soft surface. Firmly pull up on the Mop Pads to remove from Mop Pad Drivers. Replace Mop Pads if damaged. Machine wash separately in warm water. Use only liquid detergents. Do not use bleach or fabric softener. Tumble Dry on low. Do not iron or dry clean. To reattach, use the middle hole on the pads to align with the driver. While in mopping mode, your

Handle for the Hard Floor Expert 1154 Series | Hard Floor Expert Vacuum Hose with Handle | 1602341

Hard Floor Tool for Canister Vacuums. | Hard Floor Tool for Canister Vacuums | 1602265

Hard Floor Tool for Select Canister Vacuums including Hard Floor Expert, 1547 series. | Hard Floor Tool for Select Canister Vacuums | 1607462

Hard Floor Tool fits the Hard Floor Expert Cordless Canister Vacuum - Series 2001 | Hard Floor Tool for Select Canister Vacuums | 1610619

Bare Floor Tool fits select Upright Carpet Cleaning Machines, Including Series: 2084, 2085, 2089. To attach the Bare Floor Tool to your machine, follow these directions: With foot, press the red power more→button, to turn off unit and then unplug. Remove the clean water tank lifting straight up and away from lower body. Release Collection Tank latches (on each side) by pulling up from the bottom of latch and then out. Attach the hard floor tool by hooking it into the front of the nozzle. Rotate down until it snaps into place. Return both tanks to the machine and plug into a proper outlet. | Bare Floor Tool for Select Carpet Cleaners | 1617193

Hard Floor Tool for Select BISSELL Canister Vacuums, this part does include the brush as well. Fits Hard Floor Expert, Series 1161 | Hard Floor Tool with Brush for Canister Vacuums | 1602090

Power Foot for the BISSELL Pet Hair Eraser Premium Canister Vacuum, Series 2230. | Power Foot for Select Canister Vacuums | 1622434

PowerFoot for the Pet Hair Eraser Cordless Hand Vacuum, Series 1782. | Power Foot Pet Hair Eraser Cordless Hand Vacuum | 1608655

Separator Assembly fits inside the Dirt Tank. To clean the Separator Assembly, follow these instructions: Hold the dirt tank over a trash container. Press the bottom release button to empty. Twist Sep more→arator Assembly counter-clockwise and pull down to remove. Tap Separator Assembly against inside of trash container and rinse under warm water, if necessary. Let dry completely before reinstalling. | Separator Assembly | 1639789

Dual Separator Assembly for Cleanview Rewind Models 2970, 3247, 3583, 7636 and 8531. Fits inside the dirt tank. | Separator Assembly for Cleanview Rewinds | 1601515

Separator Assembly sits inside the Dirt Tank for the Hard Floor Expert Canister Vacuum - Series 1547. | Separator Assembly for Hard Floor Expert Canister | 1607937

Separator Assembly for the Powergroom Multi-Cyclonic Canister Vacuum - Series 1654 in Lime Green. | Separator Assembly for Powergroom Multi-Cyclonic | 1607938

Separator Assembly for PowerLifter Rewind 1792 Series Upright Vacuum. | Separator Assembly for Powerlifter Rewind | 1610207

Separator Assembly in Purple for the PowerLifter Upright Vacuum - Series 1793. | Separator Assembly - Purple for PowerLifter Vacuum | 1610206

Separator Assembly for the BISSELL Pet Hair Eraser Canister, Series 2230, and SmartClean Canister Vacuum, Series 2268. To clean the Separator follow these instructions: Turn the Separator system count more→er-clockwise to release and remove from the tank. The Separator system can be rinsed to clean. Let dry for 24 hours before replacing Replace Separator system and turn clockwise to lock in place. | Separator Assembly for Select Canister Vacuums | 1618601

Separator Assembly fits inside Dirt Tank. In Purple. | Separator Assembly - Purple - for Select Canister Vacuums | 1622436

Separator Assembly for BISSELL Pet Hair Eraser Corded Slim Vacuum Cleaner, Series 2897, and CleanView Pet Slim Corded Vacuum, Series 2831, and 3070. | Separator Assembly for Select Corded Slim Vacuums | 1623108

This Separator Assembly DOES NOT come with the mesh cup. It is just the filter ONLY! If you need the mesh screen you can find it here Filter/Separator Assembly for Select Hand Vacs including Pet Hair more→Eraser Hand Vac, Series 2390 and AutoMate Hand Vac, Series 2284W. To clean this Filter/Separator Assembly: Turn power OFF and remove the dirt cup. Grasp filter tabs and lift up to remove the washable filter cup from the dirt cup. Grip the filter cup and turn counterclockwise and lift down to remove filter from filter cup. Tap firmly against the inside of a waste container, removing any visible dirt. Replace filter back into the filter cup then turn clockwise to lock into place. Attach filter cup

Separator Assembly fits inside the Dirt Tank of Select BISSELL Stick Vacuums, including CleanView Pet Slim, and PowerGlide Pet Slim, Series 2903, 2921, 3080. To empty the dirt tank, you must remove th more→e separator from the dirt tank. Here's how: Turn OFF your machine. Remove the Dirt Tank from the Hand Vacuum by pressing the Tank Release Button on the front of the tank. Grab the middle grip of the filter and pull up. This will activate a wiping feature to remove debris from the mesh filter screen. Twisting the grip will remove the filter only. Fully remove the separator from the tank and tap the mesh screen on the side of the trash bin. Dump dirt from the tank into the trash bin. Slide the