Surge Protectors & Extension Leads Eaton

Eaton Type 1 Surge Protective Device - 120 V AC, 230 V AC Input - 120 V AC, 230 V AC Output

Cooper Wiring 7Outlet Surge Protector Strip 1176V
COOPER WIRING DEVICES INC

6 grounded standard outlets Master On/Off switch for convenient control of all plugs
"Load-Protected" LED will shut off if the surge suppression circuitry is no longer functional
15 Amp resettable circuit breaker provides overload protection
3-year
4-ft power cord

Steel mounting strap is zinc-plated for added corrosion resistance
Convenient patented built-in wire stripper speeds installation
Backwire Clamps on side Terminals provide for easy installation of #12 and #14 awg wire
Terminal screws are backed out and ready for wiring to enhance ease of installation
Break-off provision for wiring both devices on the same circuit or on separate circuits

Fully Complies with NEC and OSHA Regulations for Construction Sites
Power Indicator Lamp Goes Off if GFCI Trips, Power is Interrupted or Line Cord is Unplugged
2 FT Cord, 12/3 AWG
Tri-Tap plug style
NEMA 3R rated for indoor/outdoor use

Converts a single outlet receptacle into a three outlet receptacle
Uses 15-Amps with 125-volts and comes with 2-pole, 3-wire feature
The swivel feature hugs the cord close to the wall so you can use it in tight-spaces such as behind furniture or office equipment

Operates with 20-amps and 125-volts
Comes with a nickel-plated strap and mounting screws and stainless steel terminal screws to protect it against corrosion
Provides compliance with 2011 NEC article 406.9 that states that all receptacles that are placed in a wet or damp locations must be weather resistant
Is manufactured with the highest grade of materials, which makes its impact-resistant thermoplastic face and back body virtually unbreakable
Terminals screws come already backed out to help with the ease of installation
Total Power Outlets : 2

Steel mounting strap is zinc-plated for added corrosion resistance
Convenient patented built-in wire stripper speeds installation
Backwire Clamps on side Terminals provide for easy installation of #12 and #14 awg wire
Terminal screws are backed out and ready for wiring to enhance ease of installation
Break-off provision for wiring both devices on the same circuit or on separate circuits

Audible alarm signals when surge protection has expired and stays on until module is removed or replaced
Patented replaceable module restores expired surge protection without interruption of power or need to remove and rewire device
Surgebloc snap-in replacement module requires no rewiring or interruption of power to restore protection
Green led indicators to verify surge protection and ground

Surge Protector
SPD
Nema-1
277/480V

120/208V 50/60Hz
SCCR : 200kA
NEMA Type 1 Enclosure
SPD Series

Powerwarte surge protection pvl
50kA surge rating
Powerware PVL, 480y, NEMA 1 Enclosure
480 Volts Minimum
Supressed voltage rating with fusing

Used For 30-Amp 250-Volt With A Nema L6-30C Applications
Features A Smooth, Tapered Body That Reduces Snagging And Provides Easy Handling
Has Neoprene Gasket Seals Around The Cord For Added Terminal Protection From External Elements
From The Brand Name: Eaton

Used for 20-amp 250-volt with a NEMA L6-20C applications
Features A Smooth, Tapered Body That Reduces Snagging And Provides Easy Handling
Has Neoprene Gasket Seals Around The Cord For Added Terminal Protection From External Elements
From The Brand Name: Eaton

CHC320TS1 C-H C320TS1. TRANSIENT SUPP 120V

Surge Breaker, Type CL, 2-Pole, 1-Phase, 120/240 VAC, LED Indicator For Operational Status