Nails, Screws, Fasteners Point

1/2 in. knurled Powder Actuated Pin is used to attach sheet metal to structural steel, using a powder actuated tool.

".145 shank x 3/4"" Powder Actuated Pin, used in all Powder Actuated tools"

1 in. x .145 in. shank Drive pin is used with most powder actuated tools.

.157 shank x 1/2 in. knurled drive pin is used for hard structural steel. The ballistic point and thicker shank diameter provides a more consistent fastening in hard steel.

2 in. x .145 in. shank powder actuated pin, to be used with most powder actuated tools.

1-1/2 in. x .145 in. shank powder actuated pin to be used with most powder actuated tools.

.22 Caliber Powder Actuated loads for use in most .22 caliber tools

.22 Caliber single shot loads for use in .22 Caliber Powder Actuated Tools

.22 Caliber Yellow loads that are used in most .22 caliber tools

2-1/2 in. and .145 in. shank diameter drive pin to be used with most powder actuated tools.

2-1/2 in. x .300 shank diameter pin mechanically galvanized for use with ACQ Lumber. To be used with most powder actuated tools.

3 in. x .145 in. shank diameter drive pin to be used with most powder actuated tools.

"1-1/2 in. x .145 in. shank diameter pin with a 1"" washer to be used with most powder actuated tools."

1 in. x .145 in. shank diameter drive pin with 1 in. washer. This pin is to used in most powder actuated tools.

Blue Point .27 caliber Powder Actuated Strip loads for use in most .27 caliber tools on the market

Blue Point .27 caliber Powder Actuated Strip loads for use in most .27 caliber tools on the market.

Blue Point .27 caliber Powder Actuated Strip loads for use in most .27 caliber tools on the market

1-1/4in. x .145 in. diameter shank drive pin with 1 in. washer. Used with most powder actuated tools.

2 in. x .145 in. shank diameter drive pin with a 1 in. washer. This is to be used with most powder actuated tools.

2-1/2 in. x .145 in. shank diameter drive pin with 1 in. washer to be used with most powder actuated tools.

3 in. x .145 in. shank diameter drive pin with a 1 in. washer. To be used with most powder actuated tools.

"The BP307S is a Low Velocity Powder Actuated, single shot, .22 caliber tool which can be used to install .300""-.315"" head drive pins and 1/4""-20 threaded studs, up to 3” in total length. The BP307S is designed for maintenance, residential and commercial contractors."

This .27 Caliber Powder Actuated strip tool is the workhouse of the industry. It has a 1/2 in. thru 3 ft. washer pin capacity, making it one of the most versatile tools in the industry.

This .27 Caliber Powder Actuated Tool is the quietest tool in the industry at 60 decibels. It is also power adjusts.