USA
Catalog   /   Home & Renovation   /   Bathroom & Taps   /   Bathroom & Shower   /   Heated Towel Rails

Comparison LARIS Euromix E Euromix S3 E R 600x1200 73207691 vs LARIS Euroflesh Shelf E R 500x1000 73207613

Add to comparison
LARIS Euromix E (Euromix S3 E R 600x1200 73207691)
LARIS Euroflesh Shelf E (R 500x1000 73207613)
LARIS Euromix E Euromix S3 E R 600x1200 73207691LARIS Euroflesh Shelf E R 500x1000 73207613
Outdated ProductOutdated Product
TOP sellers
Main
The S3 controller has three operating modes: "min", "mid" and "max". The modes are switched by touching the sensor (<2 seconds). The sensor is located below on the rack with the regulator. The regulator has the function of turning off the heating by timer.
The regulator has four power levels. When disconnected from the network, the set temperature level is stored in memory.
Typeelectricelectric
Designthree-dimensional ladderthree-dimensional ladder
Specs
Power consumption235 W150 W
Max. operating t55 °C55 °C
Thermostat
Timer
Display
Controlelectronictouch controls
Power cablerightright
Centre distance600 mm500 mm
Number of jumpers128
Jumper cascade
Drying shelf
Material
steel /stainless AISI 304/
steel /stainless AISI 304/
Coating
bronze
gold
stainless steel
white black
bronze
gold
stainless steel
white black
Country of originUkraineUkraine
Manufacturer's warranty20 years20 years
Dimensions (WxHxD)630x1200x203 mm545x1010x301 mm
Color
Added to E-Catalogmarch 2023march 2023

Power consumption

The maximum power consumed when operating an electric towel rail (or combined model when operating from an electrical grid; see «Type»). As a rule, this value corresponds to the operating thermal capacity of the electric heater, so that it is possible to estimate the overall efficiency of such devices from the power consumption. In addition, energy consumption and network load depend on this indicator.

As a rule, manufacturers select the power consumption depending on the size of the towel bar - to ensure it is sufficient for heating and effective drying. This requires relatively little energy. But in the role of a heater for the bathroom is more convenient to use water heaters - they are easier to achieve high power (and such heating is cheaper). Therefore, electric heaters in modern models have low power - the devices more than 150 W are rare, and the most low-power devices do not reach and 50 W.

Display

The presence of the display on the body of the towel heater allows you to see more clearly the set temperature or timer settings. This solution improves the comfort of use of the device, but also affects its total cost.

Control

Towel rail controls can be represented by mechanical, electronic or touch programmers.

Mechanical. Rotating handles or buttons directly connected to the control elements of the towel rail, in particular, a thermostat or thermostat for changing the heating intensity. This control is extremely simple and inexpensive, but its possibilities are very limited, and the accuracy of adjustments is lower than in electronic systems. Mechanical controls can be mounted on both the plug and towel rail.

Electronic. Button control via electronic circuits. Although it is more expensive than mechanical, it provides more possibilities and increases the accuracy of temperature adjustments.

Touch. It’s a kind of electronic system where the controls are not buttons, but sensors that respond to touch. The touch panels look more modern and have no protruding parts, making them less polluted and easier to clean. Touchscreen programmers are usually equipped with expensive models of towel warmers.

Centre distance

The distance between the axes of the main pipes connecting the towel rail. This parameter is critical in the selection of water towel rail and its frames into existing pipes. To ensure a neat design after installation, the spacing between the towel rail and the pipe in the wall must be the same. If the figures match, you will not need to use accessories in the manner of plumbing knees, adapters, adapters, etc. The classical dimensions for the interaxial distance are 400 mm, 500 mm and 600 mm.

Number of jumpers

Number of jumpers - horizontal elements - provided in the design of the towel rail. It is on them are placed towels and other things designed to dry; however, there are models in which not every jumper is suitable for this. The fact is that horizontal elements can be placed in groups, inside which the distance between them is so small that it is very difficult, if not impossible, to place a towel there. In such groups, only the upper bridge supports, and the rest play the role of additional heating elements, increasing the heating area and, accordingly, the efficiency of drying the fabric. This feature is quite common in models with more than 10 jumpers.

It can be said that, in theory, the more jumpers - the more things can be hung on the towel rail; however, in practice, this moment largely depends on the design of a particular model, And the more horizontal elements there are, the more likely they are to be grouped. Also, it is worth paying attention to the width of the towel rail, according to this criterion you can conventionally divide them into broad and narrow.

Drying shelf

Presence in the towel rail shelf - a constructive element that allows you to place the dried fabric horizontally. Most often it is not a solid shelf in the classical sense, and several jumpers (usually 2-3) located between two horizontal tubes. The shelf increases the overall capacity of the structure without extending its vertical dimensions, and in some cases drying on it is more efficient than on traditional jumpers.