Comparison TP-LINK M7450 vs TP-LINK M7350

Connection speeds via Wi-Fi, specifically the Wi-Fi standards supported by the modem with corresponding capabilities (see “Type,” “Connection”).

— Wi-Fi 3 (802.11g). This is an advancement of the Wi-Fi 1 standard (802.11b), developed primarily to increase connection bandwidth (2.4 GHz) and introduced in 2003. The 802.11g equipment is fully backward compatible with 802.11b, so even the simplest of modern Wi-Fi devices support both of these standards.

— Wi-Fi 4 (802.11n). A Wi-Fi standard that is a further development of the formats described above — particularly by adding MIMO technology support (distribution of input and output between multiple antennas). Introduced in 2009. The main operating frequency is 2.4 GHz, although devices with an additional 5 GHz band can be found.

— Wi-Fi 5 (802.11ac). Built on 802.11n, introduced at the end of 2013. The main improvements involved increasing the number of streams on the second frequency (5 GHz) and implementing more advanced MIMO and modulation standards, which allowed for a corresponding increase in bandwidth.

— Wi-Fi 6 (802.11ax). The Wi-Fi 6 version delivers the internet via the modern 802.11ax standard in the 2.4 and 5 GHz bands, handling a large number of connected devices better. This modem is especially convenient where smartphones, laptops, TVs, and smart devices use the network simu...ltaneously because Wi-Fi 6 more efficiently distributes traffic and reduces delays in a busy network. Compared to Wi-Fi 5, the difference is usually felt not so much in “peak” speed but in more stable performance during streaming, video calls, and online gaming.

— Wi-Fi 6E (802.11ax). Essentially the same as Wi-Fi 6, but with the addition of a 6 GHz band, making the connection more stable, especially in crowded places. In practice, this is especially useful in an apartment building with many neighboring networks. However, the main point is that the advantage of Wi-Fi 6E is realized only on devices that also support 6 GHz. This frequency allows for a separate channel to be allocated with fewer interferences from other devices.

— Wi-Fi 7 (802.11be). A step further compared to Wi-Fi 6E: it offers even higher speed, lower latency, and more stable network performance under load. Its key advantages over the previous version are related to channels up to 320 MHz and Multi-Link Operation, where the device can use several bands simultaneously instead of just one. In practice, this is particularly useful if the modem is to replace the main home router and deliver fast 5G directly to a laptop, gaming PC, TV with 4K/8K content, NAS, and other demanding equipment. In other words, Wi-Fi 7 is for when not just fast Wi-Fi is needed, but a noticeable reserve in speed and responsiveness for the future.

The largest number of devices that can be simultaneously connected to the modem via Wi-Fi (see "Connection").

The presence of this limitation is due to the fact that processing network requests from several devices at once requires a fairly large amount of computing resources, and there are not so many of them in miniature electronics like wireless modems. However, even inexpensive models can support about 5 – 6 devices, which is more than enough for most cases; and in more advanced modems, this number can reach 10.

The 4G (LTE) mobile connection speed supported by the modem.

All modern LTE equipment is assigned one or another category (Cat.3, Cat.4, Cat.6, Cat.7, Cat.9, Cat.12, Cat.13, Cat.16, Cat.18, Cat.19, Cat.20, Cat.22), on which the transmission speed directly depends. This paragraph specifies both this category and specific speed indicators, moreover, in two parameters — for reception and for transmission. The transmission speed is always much lower, but given the specifics of mobile Internet access, this is usually not critical.

Note that equipment with different speed categories will be quite compatible with each other, however, the throughput will be limited by the capabilities of the slower device. It is also worth saying that this paragraph indicates the theoretical maximum; practical amounts can be noticeably lower (depending on the quality of the network coverage and the features of specific electronics). However, a modem with a higher speed category will perform faster in fact.

Data transfer technologies supported by the modem.

— GPRS. The oldest communication technology in use today. It was developed as a standard for GSM cellular networks, allowing data to be transmitted in parallel with voice communications and text messages, as well as charging network access by the amount of data transmitted, and not by connection time (as in the previous CSD standard). At the time of its creation, it was very progressive, but now it is considered completely obsolete and is used only in cases where more advanced standards cannot be used.

— EDGE. A technology created as a modification of the GPRS described above, which would increase the channel throughput and improve communication reliability. Otherwise, this standard is completely similar to GPRS in terms of its main practical features.

— W-CDMA. One of the early third generation ( 3G) communication standards. Used in UMTS networks. One of the main advantages of such networks is the ability to build networks based on the existing GSM infrastructure. Therefore, UMTS, and specifically W-CDMA, is being used by many mobile operators in the early stages of their transition from 2G to 3G.

— HSUPA. Third generation (3G) communication technology, an evolution of W-CDMA described above. The name stands for "Hi...gh-Speed Uplink Packet Access" — high-speed packet data transmission in the "from the subscriber" direction. This, in fact, describes the purpose of this technology: it increases the speed of data transfer from the modem to the base station, which can be useful for some specific tasks — for example, video communications.

— HSDPA. Further, after HSUPA, improvement of the W-CDMA standard (see above). It belongs to third generation (3G) networks, but is considered an “extended” standard, which is why HSUPA-enabled networks can be referred to as 3.5G, 3G+, etc. The name itself — "High-Speed Downlink Packet Access" — translates as "high-speed packet data transmission from the base station to the device."

— HSPA+. Today's most advanced third-generation communication standard based on UMTS networks (W-CDMA). Thanks to a number of improvements, it allows to achieve higher speeds than the options described above, approaching fourth-generation networks in terms of capabilities; therefore, sometimes conventionally referred to as 3.75G.

— WiMAX. Initially, WiMAX was created in two versions — "mobile" and "stationary"; the vast majority of modern cellular modems use the second option. It belongs to the fourth generation standards — 4G (whereas "mobile" was a competitor to 3G technologies, although sometimes it is also referred to as a 4th generation connection for marketing purposes). Some time ago, WiMAX was actively promoted as an alternative to wired broadband Internet connection (in particular, as the best option for areas, where it is difficult to reach the cable). However, now this standard is gradually losing popularity — in particular, in connection with the development and promotion of a more advanced LTE (which also does not have a division into "mobile" and "stationary" varieties).

— LTE (up to 173 Mbps). The fourth generation cellular communication standard, the most popular 4G technology today — in particular, due to the fact that it is a further development of W-CDMA/UMTS and can be implemented by improving existing networks (both UMTS and CDMA2000). Another reason for the popularity is the same convenience for both stationary and mobile equipment. On the other hand, when choosing a modem of this standard, you should keep in mind that LTE bands and channels may differ in different countries, so the support of this technology does not guarantee compatibility with a particular network. It should also be taken into account that in some countries LTE networks are only at the deployment stage, and in some they are not available at all.

When evaluating the capabilities of a modem, note that the speed values given for each technology are the maximum, which in fact is achievable only under perfect conditions. The actual values of the speed, usually, are lower than the potential ones; they may depend both on the specs of the network, signal strength and other technical issues, and on the policy of the operator and the conditions of a particular tariff.

The capacity of the battery installed in the modem with the corresponding type of power supply (see below).

The higher the capacity, the longer the battery is able to work without recharging, all other things being equal. However, note that the situation of "other things being equal" is almost not found in modern wireless modems. First, different data transmission technologies (see above) have different power consumption; secondly, even models supporting the same standards can differ in power consumption (and battery life) due to design differences. Therefore, this indicator in most cases is purely reference information, and even very similar models can only be compared approximately. When choosing, it is worth focusing primarily on the claimed specs of the battery life (see below).

The maximum operating time of the modem with battery power (see "Power") on a single charge in Internet browsing mode. Such power is typical for Wi-Fi routers, therefore, usually, Internet browsing is supposed to provide access to the World Wide Web for an external Wi-Fi device.

This spec is the main indicator of battery life for any battery-powered modem, because it describes the time of using it for its main purpose without recharging. At the same time, you should know that this indicator is measured under certain "perfect" conditions; the actual operating time depends on a number of factors, including the intensity of browsing, the amount of data transferred, the number of connected devices and the distance to them, the cellular network signal strength, etc. Therefore, in fact, the battery life of the modem may be somewhat lower. Nevertheless, it is quite possible to compare different models with each other according to the operating time stated in the specs.