USA
Catalog   /   Automotive   /   Parts & Car Electronics   /   Chargers & Jump Starters

Comparison Sturm BC1212 vs Intertool AT-3011

Add to comparison
Sturm BC1212
Intertool AT-3011
Sturm BC1212Intertool AT-3011
Outdated Product
from $48.84 up to $61.00
Outdated Product
TOP sellers
Deviceboosterbooster
Specs
Battery voltage
12 V
12 V
Starting current300 А300 А
Peak output current400 А600 А
Built-in battery capacity12000 mAh16800 mAh
Charging gadgets (outputs)
DC connector for gadgets
General
Built-in flashlight
Power source12/230 V12/230 V
Size225x192x80 mm165x79x40 mm
Weight1.3 kg
Added to E-Catalogapril 2019march 2015

Peak output current

Peak inrush current of the starter or booster (see "Type").

Peak current is the highest current that the device can deliver without problems for a short time (1 – 2 s). This current is noticeably higher than the nominal starting current (see above), which corresponds to the operation of a car starter: starting to spin up, the starter consumes a very high current, which, however, decreases almost immediately.

The peak inrush current of the ROM or booster must not be less than the peak inrush current of the starter. You can specify the latter according to the documentation for the car, or according to the characteristics of a regularly used car battery.

Built-in battery capacity

Capacity of the own battery provided in the design of the starter-charger.

As a rule, boosters and launchers with a power bank function are equipped with their own batteries (see “Type”). The main purpose of such a battery from the point of view of helping to “light up” is to provide the power necessary to start the engine. However, in some models the battery is responsible for other functions, such as the built-in compressor or flashlight. The larger the battery capacity, the longer the device can operate, and the more tasks it can perform on a single charge.

In starting devices with the powerbank function, this parameter is also given to estimate how much energy the battery can accumulate and then transfer to connected gadgets. It is important to consider that there is a nominal (declared) and real capacity - the latter is always less, because it takes into account the inevitable losses during energy conversion. Typically the difference is from 30 to 40%, i.e. a model with a conventional battery capacity of 10,000 mAh will not fully charge a smartphone with a 3,000 mAh battery three times, but at best will provide two power cycles, because in practice its working capacity is about 6,000 mAh. Therefore, it is not entirely correct to compare the mAh values of your gadget’s battery with the nominal capacity of the built-in battery - you should definitely take into account that the real capacity is always less than the “rated” one.
Sturm BC1212 often compared
Intertool AT-3011 often compared