Aircraft NX3 3D Flight Controller Gyroscope Balance For Fixed-wing RC Airplane

NX3 PRO flight controller Click HereDescription Voltage Range 5 6V DC Dimensions 40mm x 25mm Weight 6 5g Feature 1 Four Model Types supported single aileron dual ailerons flapperons for delta and vtail 2 Three Flight Modes supported 　a Rate Mode Rate Mode for offset correction 　b Hold Mode HOLD mode for attitude hold　c Gyro Off Mode transsmiter control the plane directly 3 Two kinds of Gain Control Method supported Master Gain from the radio Independent Axis Gain from the Variable resistor on the Controller board 4 Using superior algorithm Bring a more comfortable and more sensitive sense of control VERY IMPORTANT The Controller has to re learn center position after installation or replacing a new radio system or making a trimming or Sub Trim change within the transmitter otherwise the servos may move to one side automatically when switching to hold mode To do this just quickly flip the flight mode switch twice between rate mode and hold mode within 1 second Status LED Description LED OFF NX3 in Gyro Off Mode LED ON NX3 in Rate Mode LED flash NX3 in Hold Mode WARNING PLEASE READ THE FOLLOWING STEPS VERY CAREFULLY BEFORE YOU START TO INSTALL A NEW PLANE Step 1 MountingThe board need to be firmly mounted near the center of the gravity of the plane by using the double tape provide Please make sure the longer side of the board is along with the heading direction After mounting please check again if the board is attached firmly in the plane Step 2 Model Ty