Type
-
Monocrystalline. Monocrystalline solar panels are made from solid silicon crystals of a homogeneous structure. They have the highest efficiency among other types - up to 22% of solar energy is converted into electrical energy. Monocrystalline panels can be recognized by the black color of the working surface. They are suitable for installation with limited installation space. The other side of the coin of monocrystalline solar panels is a labor-intensive and expensive manufacturing process, which translates into a high cost.
-
Polycrystalline. The cell of such panels consists of a large number of heterogeneous silicon crystals and includes a small amount of secondary raw materials (impurities from recycled solar panels or silicon waste from the metallurgical industry). The color of polycrystalline solar panels is dark blue. Such a structure slightly reduces the efficiency (up to about 16-18%), however, these panels are cheaper than monocrystalline ones and work effectively even in weak sunlight.
-
Amorphous (thin-film). Amorphous silicon thin-film modules use substances that consist of thin silicon layers (about 100 times smaller than in crystalline silicon), which allows them to be flexible and retain their functions. Amorphous panels are a thin transparent film. Such panels are inferior to crystalline counterparts only in terms of efficiency (in the re
...gion of 7-12%) and durability. However, they capture ambient light better on cloudy days and lose less power as the surface heats up. However, thin-film solar panels are inexpensive.Specs (STC)
Standard Test Conditions (STC) are standard test conditions that reflect the operation of a solar panel under ideal conditions. As part of the tests, the weather of a clear sunny day with an air temperature of +25 °C, no wind, solar intensity of 1000 W/m² and an emission spectrum relative to air mass of 1.5 is simulated. The surface of the solar cell must be placed strictly perpendicular to the rays from the celestial body. Note that in real operation of the solar panel, such conditions are extremely rare. However, in general, the characteristics of the STC allow us to evaluate the "passport" parameters of the energy storage device.
Power (Pmax)
The amount of electricity in watts that a solar panel produces in one hour in tests using the STC method. The panel must provide the declared number of watts during normal operation.
Nominal voltage (Vmp)
The value on the voltmeter when testing the solar panel at the nominal power level according to the STC method. The Vmp parameter is measured in volts. It stands for Voltage at Maximum Power. Allows you to determine for which type of batteries the panel is provided - for
12 V or for
24 V.Nominal power (Imp)
Ammeter reading during solar panel testing under STC conditions. The value of the rated current Imp (Current at Maximum Power) is measured in amperes.
Open-circuit voltage (Voc)
The voltage generated by the solar battery in idle mode, that is, without connecting the load. Behind the abbreviation Voc stands for Voltage Open Circuit.
Short circuit current (Isc)
The current value under the condition of zero voltage (Short Circuit Current).
Efficiency
Percentage of the maximum solar panel power to the incident radiation power produced. The efficiency parameter allows you to determine how efficiently the panel PV module converts solar energy into direct electric current.
Specs (NOCT)
The characteristics of NOCT (Nominal Operating Cell Temperature) reflect more realistic operating conditions for solar panels. Testing according to this method is carried out at a lighting intensity of 800 W/m², an air temperature of +20 °C and a wind speed of 1 m/s. The solar battery is placed at an angle of 45° relative to the incident light rays with a south orientation. The temperature of the panel surface in this case reaches +40 - 45 °С.
