Rated power
The power generated by the meat grinder motor during operation. The efficiency of work directly depends on the power: the greater the power, the more solid products the meat grinder is able to process and, usually, the higher the capacity (see Capacity). For most cases, a meat grinder with a power of 100 – 400 W is sufficient, however, for complex work with “heavy” products, more powerful devices are still required.
Rated is the power at which the device is able to operate for a long time without overheating, breakdown and other unpleasant consequences.
Peak power
Peak power is responsible for emergency situations, the device is able to work on it for a short time, however, long-term work with such a load is fraught with a meat grinder breakdown.
Capacity
The amount of meat that the meat grinder can process in one minute. More
powerful meat grinders(see Power) are usually more performant, however, these two parameters are not directly related — the meat grinders with the same capacity may have different power, and vice versa, equally powerful devices may differ significantly in performance.
Body material
The body of a modern meat grinder is most often made of plastic or metal.
Plastic devices usually weigh less and cost less; in turn,
metal ones are more durable and look “more solid”. At the same time, there are models made of both of these materials —
plastic and metal. Such a solution elevates the models to a more status rank, but at the same time does not deprive them of lightness and design variations.
Loading tray material
The loading tray in modern meat grinders can be made of
plastic or
metal. Plastic trays are lighter and cheaper, but prone to scratches and discoloration over time, while more expensive metal trays are stronger and more durable.
Overload protection
The
meat grinder engine protection system from overheating and overload, which turns off the device in case of a critical increase in loads (for example, when a bone enters the meat grinder and the spiral auger is jammed).
Compartment/stand for storing nozzles
The presence of a separate
compartment for storing removable nozzles in the body or stand of the meat grinder. The organizer built into the meat grinder greatly simplifies the storage of working equipment. For storage of nozzles/grilles, the device provides a secret compartment covered with a lid.
Compartment for cord
A special compartment in the body of the device for storing the power cord. Often such compartments are also equipped with devices for uniform winding of the wire, which prevents bending and possible fractures.
The compartment for the cord is especially useful if the meat grinder is used relatively rare and has been idle for a long time outside the kitchen.
