Water flow
Water consumption during operation of the upper shower (cf. «Equipment»). Indicates the amount of water passing through the watering can with the tap fully open and the water pressure 3 bar (standard household water pressure).
The higher the bandwidth of the watering can be - the more powerful and intense the shower becomes. On the other hand, high water consumption is undesirable if you want to save water - for example, if you have meters installed or if water is supplied from a boiler with a small volume. In addition, it is worth remembering that the watering can have different settings and features of water supply. So, by selecting the lake with the right parameters, you can get a nice and effective top shower even when
low water flow. Actually, a low value in this case is considered to be up to 10 l /min; the average is 10 - 20 l/min, and in the most productive watering can be up to 30 l/min and even more.
Water consumption
The throughput capacity of a manual shower watering agent, in other words, the amount of water it gives out per minute when the faucets are fully open. Since the capacity is not only related to the design of the watering box, but also to the pressure in the water supply, it is customary to specify an average value - at a standard pressure of 3 bar.
The higher this parameter - the more intense the impact on the body can have a shower. At the same time, high water consumption can become a problem when there are water meters or when there are limited supplies - for example, if hot water is supplied by a boiler. Also note that
, low throughput can be compensated by certain jet settings.
Spout
— Cascade. In such vents, water is fed through an outlet in the form of a thin horizontal slit, or a wide trench (depending on the model). Due to this, the output achieves a large width of the jet at a low thickness, which provides a good throughput, as well as the original look, imitating the waterfall (hence the name). On the other hand, this form is less universal than the classical one, and it is much more expensive, and therefore is used quite rarely.
— Classic. Models in which the spout is made in the form of a tube. Such flows may have different shapes in length (straight, curved, with an angle) and cross-section (round, triangular, square, etc.), but they are all tubes.
In most cases, there is simply no drain for shower systems.
Jet depth
Distance from the wall attachment point to the aerator. It is a characteristic that determines the “reach zone” of the faucet spout.
