Comparison Btrace Highland vs Tramp Mosquito LUX

Seasons in which the use of a tent is allowed.

There are three main seasonality options: winter, spring / autumn and summer. At the same time, the design features necessary for comfortable use of the tent in different seasons are as follows:

— In winter, the tent should effectively protect against snow and wind, and its materials and fittings should normally endure a long stay in the cold. Thermal insulation is also desirable, but in general this is a secondary factor — the main insulation is provided primarily by clothing, a sleeping bag and a bed.
— In the off-season — in spring and autumn — protection from rain, which can be accompanied by strong winds, is of particular importance.
— For comfortable use in the summer heat, good ventilation is required, ideally with insect protection, such as mosquito nets.

As you can see, these requirements generally do not contradict each other and may well be combined in one product. Thus, there are very few tents on the market designed strictly for one season — two- or even all-season options are much more common. For example, even among beach tents (see "Purpose") there are models for which the possibility of using in the off-season is claimed — for this, the design provides for a dense awning, or even the ability to completely close the tent. Almost any model from the "spring-autumn" series...additionally has a summer specialization; and most models suitable for winter actually allow year-round use.

In conclusion, we recall that tents with the same seasonality and purpose can at the same time differ significantly in characteristics and design features.

The total weight of the tent is including the frame and other accessories.

This parameter depends primarily on the purpose (see above), and after that — on seasonality, capacity, and additional functions. For example, in trekking and expedition models, the weight usually does not exceed 5 – 7.5 kg, and the lightest of these products can weigh 2 – 3 kg or even less, while being full-fledged tents for 2 people or even more. However, for a trekking tent, such a small weight with a capacity of more than 2 people usually means that this model is designed exclusively for the summer. For most camping tents, the weight starts at 6 kg, although among them there are also quite light products — by 4 – 5 kg, 3 – 4 kg, or even less (in such cases, light weight can also mean a purely summer specialization). And the most capacious and/or multifunctional models can have a weight of 10 – 15 kg, 15 – 20 kg and even more; in this weight category, you can mainly find tents, camping tents for many people and fishing tents for carp fishing (see "Destination").

When choosing a tent according to this indicator, it is worth considering that it does not always make sense to chase the maximum weight reduction. Yes, the...light tent is the most convenient to carry; on the other hand, weight reduction inevitably affects one or several other characteristics at once. So, most often, lighter models are either more expensive or smaller in size and less roomy and functional than their heavier counterparts. And sometimes weight reduction also negatively affects the security (including moisture resistance) and the overall reliability of the product. Therefore, it makes sense to specifically look for the lightest tent possible in cases where weight reduction is of key importance; a typical example is long trips, in which all the equipment has to be carried “on oneself” for a long time. And even in such cases, it is worth remembering other important characteristics. For example, for use in late autumn, when frosts are likely, it is better to choose a heavier tent with winter seasonality than a light model that is not designed for winter conditions.

— Hemisphere. Tents with a frame of two (sometimes more) crossed arches. The main advantage of such a case is good resistance to wind. On the other hand, the interior space of the hemispheres is relatively small.

— Half -shell. In cross section, the semi-barrel has the shape of a half circle (or more or less similar), and its frame consists of several semicircular arcs arranged in parallel. This provides a good internal volume, but the wind resistance of this type of hull is lower than that of hemispheres (which, however, is not critical in conditions of plains and low mountains, where there are no storm winds).

— Shatrovaya. In such a case, one rack is used, located in the middle, and the tent itself has the shape of a pyramid or cone. The advantage of tents is their high height, the disadvantage is the inconvenience due to the presence of a rack inside the living space and poor resistance to wind. This form is quite rare.

— Double. The upper part of such a body is a rib, from which two sides of the awning (slopes) diverge at an angle. To create this shape, two internal supports are usually used at the ends of the tent. This design provides additional water resistance, because. the awning is located at a large angle to the drops falling from above; at the same time, due to the inconvenience created by the...supports located inside, and a number of other features, such tents are very rare.

— Cube. A hull shape found only in fishing tents (see "Intended Use"). Almost all such models are intended for winter use and ice fishing. At the same time, some of them do not have a bottom or are equipped with a hole in the bottom, which allows you to install an awning directly above the hole; others are closed from all sides, including from below, and fishing is supposed to be through the opening. However, among the cubic tents there are also demi-season/summer models, including advanced solutions for carp fishing.

A canopy is mainly used for camping tents, much less often for trekking tents, as well as separate tents and fishing tents (see "Purpose")

The canopy is a kind of "roof" over the entrance to the tent. In most models, the role of such a “roof” is played by the same part of the canopy that is used to tightly close the entrance: to turn it into a canopy, this part must be raised to a horizontal position and two complete supports should be installed under the free edge. The main function of the canopy is additional protection from the sun and rain while the entrance to the tent is open; but its design and features of application may be different. So, this feature is most popular in camping tents (see "Purpose"); in such models, the height of the canopy may exceed the height of an adult. In turn, in trekking models, the canopy is often supplemented with fabric “walls” on the sides, which significantly improves protection from rain and other precipitation. In turn, fishing tents with this element of equipment are carp fishing models, and the canopy is installed directly at the time of fishing.

Number of windowsprovided by the design of the tent. Windows provide the penetration of natural light and relieve you of the need to use additional sources of lighting during daylight hours; in addition, when properly positioned, they allow you to inspect the area without leaving the tent.

The presence of ventilation windowsprovided in the design of the tent. These windows are essentially vents and, unlike normal windows (see above), are not designed to provide light or visibility. Their main purpose is to provide an influx of fresh air and remove moisture from the tent released by people during breathing and sweating. Good ventilation is especially important if a tent (usually a camping tent, see "Use") is organizing a kitchen.

The number of poles provided in the frame of the tent. For hemispherical types (see "Shape") for 2-3 people, not intended for extreme conditions, 2 poles are considered quite sufficient; larger and/or reinforced models may have more poles. In the case of half-barrels, this amount is directly related to the length of the tent.

— Polyester. Synthetic material with good durability and waterproof performance. In addition, it is resistant to adverse effects (does not lose strength when wet, exposed to acidic and alkaline environments, temperature changes).

— Nylon. In general, the characteristics of nylon are somewhat lower than those of polyester: it tends to stretch when wet and is generally less resistant to adverse effects. At the same time, given that most owners use tents in relatively simple conditions, these points are not critical; in addition, some manufacturers use a special treatment to improve the durability of nylon.

— Polyethylene. This material is mainly used in inexpensive models of camping tents (see "Purpose") — this is primarily due to its significant weight. For other characteristics, it does not have key differences from other materials.

— Polyamide. The general name for a class of fabrics, which includes, in particular, nylon and nylon. Some manufacturers use this term for marketing purposes: "polyamide" sounds more solid than "nylon", although these materials practically do not differ in characteristics and are used in the same way — mainly in inexpensive models.

The corners of the tent are one of the "critical" places: in the unfolded state, they have almost the greatest stress, and the fabric in this place can be torn. To avoid this, many tents are equipped with reinforced corners. In this case, strength can be increased due to multi-layer sewing, special fabric or additional firmware.