Comparison Teka MTP L vs Teka MF-2 Forum L

Clear Table
Add to comparison
	Teka MTP L	Teka MF-2 Forum L
	from $56.86 up to $67.60 Outdated Product	from $36.64 up to $75.23 Outdated Product
all specs only differences
TOP sellers	Find prices on Amazon.com Find prices on eBay.com	Find prices on Amazon.com Find prices on eBay.com
Suitable for	for kitchen	for kitchen
Tap type	single lever	single lever
Spout
Shape	bent at an angle	bent at an angle
Swivel
Jet depth	225 mm	227 mm
Jet height	189 mm	140 mm
Specs
Stop valve	ceramic	ceramic
Installation
Installation	desktop (horizontal)	desktop (horizontal)
Mounting holes	1 шт	1 шт
Mounting hole diameter	33 mm	33 mm
Inlet communication	hoses	hoses
General
Material	brass	brass
Finish	chrome	chrome
Tap height	231 mm	167 mm
Country of brand origin	Germany	Germany
Color
Added to E-Catalog	august 2014	august 2014

Jet depth

Distance from the fixing point (for vertically mounted taps) or from the centre of the mounting hole (for horizontally mounted taps) to the middle of the spout. It is a characteristic that determines the "reach zone" of the tap.

Jet height

The jet height is usually specified for taps with horizontal installation (see "Type of installation"). It is measured from the base of the tap to the spout outlet. The large height of the spout is important primarily for kitchen models (see "Suitable for"), because it allows you to place large dishes in the sink. This parameter is directly related to the height of the spout (see above): the height of the jet cannot be greater than the height of the spout. Thus, in fact, one has to find a compromise between the height of the jet and the dimensions of the tap, especially if there is little space for its installation.

Tap height

The height of the tap, measured from its base or lowest point to the highest point of the spout. The height of the spout partly determines the installation possibilities — in fact, this is the minimum vertical free space that is required for the tap. In addition, in models with horizontal installation (see "Type of installation"), the spout height is related to the jet height (see below).