USA
Catalog   /   Automotive   /   Car Audio   /   Car Subwoofers

Comparison Alpine R-W12D4 vs Alpine R-W10D4

Add to comparison
Alpine R-W12D4
Alpine R-W10D4
Alpine R-W12D4Alpine R-W10D4
Compare prices 1Compare prices 1
TOP sellers
Application areacarcar
Designwithout bodywithout body
Typepassivepassive
Size12" (30 cm)10" (25 cm)
Tech specs
Rated power750 W750 W
Max. power
2250 W /Peak/
2250 W /Peak/
Frequency range24 – 200 Hz26 – 200 Hz
Sensitivity84 dB82 dB
Dual voice coil
Impedance
4 ohm /single coil/
4 ohm /single coil/
Resonant frequency28 Hz31 Hz
General
Diffuser materialcompositecomposite
Materialaluminiumaluminium
Woofer Diameter300 mm250 mm
Woofer depth162 mm149 mm
Added to E-Catalogoctober 2017october 2017

Size

The size (diameter) of the main subwoofer speaker. In all types of subwoofers, this parameter primarily affects the power and depth of sound: the larger the speaker, the louder it is and the deeper the bass it can provide (ceteris paribus). However with an increase in the size and dimensions, they increase accordingly, which determines the installation possibilities. The latter is especially true in Free Air subwoofers (see "Execution"): some cars are initially equipped with "seats" for a certain size, and it is difficult to install models with other dimensions there.

Now on the market there are subwoofers with such popular sizes: 5" (13 cm), 6" (15.25 cm), 6.3" (16 cm), 6.5" (16.5 cm), 6.75" (17 cm), 8" (20 cm ), 8.25"(21cm) , 9" (23cm ), 10" (25cm ), 11" (27cm), 12"(30cm) , 13" (33cm), 15"(38cm) , 16 " (40 cm), 18" (46 cm).

Frequency range

The range of audio frequencies reproduced by the subwoofer. It is believed that the human ear is capable of perceiving a frequency range of the order of 16 – 20,000 Hz, but in this case note that the subwoofer is designed to reproduce the lower frequency band (up to 200 Hz). Accordingly, in the case of the lower limit of the range, everything is simple: “the lower, the better”; the upper one should not be lower than the lower limit of the main car audio — otherwise there will be "gaps" in the frequencies, which will affect the sound quality.

Sensitivity

Sensitivity determines the loudness of the subwoofer when a signal of a certain power is connected to it: with equal signal power and impedance (see below), the subwoofer with the higher sensitivity will sound louder.

Resonant frequency

The natural frequency of the cone in the subwoofer speaker, namely the frequency with which the cone will oscillate if the speaker is suspended freely in the air and a single impulse is transmitted to the cone (for example, by clicking on it with your finger). In subwoofers, this parameter determines, in particular, the lower limit of the frequency range (see above): at frequencies below the resonant sound power drops sharply. Accordingly, for deep rich bass, the resonant frequency should be as low as possible. This parameter is also used to calculate the size of the enclosure for the subwoofer.

Woofer Diameter

Subwoofer main speaker size. The diameter of the woofer determines the size of the device (see above).

Woofer depth

The size of the main subwoofer speaker from the front (usually the frame protruding beyond the diffuser) to the rear edge (where the magnet is usually located). In practice, it matters when selecting enclosures for frameless models, as well as when installing Free Air (see "Design"): this is the depth to which the speaker will be "recessed" into the enclosure or trunk. And a flat subwoofer will not always produce less bass than its more voluminous counterpart.
Alpine R-W12D4 often compared