USA
Catalog   /   Computing   /   Components   /   RAM

Comparison HyperX Fury DDR3 1x4Gb HX316C10FB/4 vs HyperX Genesis DDR3 KHX1600C9D3/4G

Add to comparison
HyperX Fury DDR3 1x4Gb HX316C10FB/4
HyperX Genesis DDR3 KHX1600C9D3/4G
HyperX Fury DDR3 1x4Gb HX316C10FB/4HyperX Genesis DDR3 KHX1600C9D3/4G
from $827.04 
Outdated Product
from $53.62
Outdated Product
TOP sellers
Memory capacity4 GB4 GB
Memory modules11
Form factorDIMMDIMM
TypeDDR3DDR3
Specs
Memory speed1600 MHz1600 MHz
Clock speed12800 MB/s12800 MB/s
CAS latencyCL10CL9
Memory timing10-10-10-309-9-9-27
Voltage1.5 V1.65 V
Coolingradiatorradiator
Module profilestandardstandard
Module height32.8 mm
More features
overclocking series
overclocking series
Color
Added to E-Catalogmay 2014april 2011

CAS latency

This term refers to the time (more precisely, the number of memory cycles) that passes from the processor's request to read data to granting access to the first of the cells containing the selected data. CAS latency is one of the timings (for more details, see the "Memory Timings Scheme" section, where this parameter is designated as CL) — which means that it affects performance: the lower the CAS, the faster this memory module works. However this is true only for the same clock frequency (for more details, see ibid.).

Now there are memory modules on the market with the following CAS latency values: 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 24, 30, 32, 36, 38, 40, 42, 46.

Memory timing

Timing is a term that refers to the time it takes to complete an operation. To understand the timing scheme, you need to know that structurally RAM consists of banks (from 2 to 8 per module), each of which, in turn, has rows and columns, like a table; when accessing memory, the bank is selected first, then the row, then the column. The timing scheme shows the time during which the four main operations are performed when working with RAM, and is usually written in four digits in the format CL-Trcd-Trp-Tras, where

CL is the minimum delay between receiving a command to read data and the start of their transfer;

Trcd — the minimum time between the selection of a row and the selection of a column in it;

Trp is the minimum time to close a row, that is, the delay between the signal and the actual closing. Only one bank line can be opened at a time; Before opening the next line, you must close the previous one.

Tras — the minimum time the row is active, in other words, the shortest time after which the row can be commanded to close after it has been opened.

Time in the timing scheme is measured in cycles, so the actual memory performance depends not only on the timing scheme, but also on the clock frequency. For example, 1600 MHz 8-8-8-24 memory will run at the same speed as 800 MHz 4-4-4-12 memory—in either case timings, if expressed in nanoseconds, will be 5-5-5-15.

Voltage

The nominal voltage required for the operation of the memory module. When choosing memory, you must pay attention to the fact that the appropriate voltage is supported by the motherboard.
HyperX Fury DDR3 1x4Gb often compared