—
Canopy. The presence of a canopy in the design of the pool. The main function of such a "roof" is to cover the people inside from the sun's rays. In addition, with the proper dimensions, the canopy can play the role of protection from the rain. Usually, canopies in modern frame pools are made removable.
—
Staircase. Frame pools with sides from a height of 1 metre, usually, are equipped with special ladders. In the absence of the latter, getting in and out of the pool is quite inconvenient, and in some cases even traumatic. The user can always purchase the required ladder separately, but here it is worth paying attention to the fact that the ladders included with the pool are ideally adjusted to the height of the sides, which makes it more convenient and safe to use.
—
Awning. The presence of an awning in the scope of delivery of the pool. An awning in this case means a “cover” made of fabric or other soft material, which can be used to cover the pool during non-working hours. Thanks to such a “lid”, leaves, insects, dust and other contaminants do not get into the water. Third-party devices can also be used to protect against debris, however, a complete awning, usually, is much more convenient: it optimally matches the dimensions of the pool, moreover, it is often equipped with devices for secure fastening.
—
Bedding.... The presence of bedding in the scope of delivery of the pool. The main function of such a product is additional protection of the bottom from punctures: the litter covers small pebbles, twigs and other similar objects, due to which the probability of an “accident” is, if not eliminated, then at least significantly reduced. In addition, the pads are usually larger than the tank itself, go beyond its edges and can be used as an impromptu “rug” for swimming: for example, it is more convenient to take off your shoes before climbing into the pool and put on your shoes again on the pad, and not on the bare earth.General dimensions of the pool in the unfolded position. In general, this is a fairly obvious parameter; we note only a couple of important points:
— In the largest models, the length or size can
exceed 6 m, in the smallest models it does not even reach 2 m.
— It is worth keeping in mind that a frame pool should be filled with water no more than 80%. Accordingly, the maximum depth of such a structure will not exceed 80% of the total height. For example, the category of
deep frame pools usually includes products with a height of more than 130 cm - accordingly, the working depth in such models is slightly more than 1 m (130 * 0.8 = 104 cm). And for the younger generation, children's's
frame pools are provided, with a side height of up to 60 cm (and a water depth of about 50 cm, respectively)
