Comparison Nektar SE25 vs Akai LPK-25

The hardness of the keys on a keyboard is the amount of resistance they provide when pressed.

— Unweighted. Very low rigidity: the keys literally "fail" under the fingers. Found mostly in entry-level keyboards; this is due to the fact that unweighted mechanics are inexpensive, but the low pressure resistance makes it difficult to select the optimal pressure and control the dynamics of the sound.

— Semi- weighted. Keyboards with medium resistance — not as high as on weighted keys, but noticeably higher than on unweighted ones. This option is considered optimal for active keyboards (see "Mechanics"): at a low cost, it gives quite good responsiveness and, with a minimum skill, allows you to accurately control the pressing force.

— Weighted. Keyboards with high resistance, which is comparable to the resistance of classical piano keys. Note that high effort in this case is an advantage: it allows you to bring the response of the keyboard as close as possible to the response of a classical piano and makes it easier to control the pressure and dynamics of the sound. Actually, by definition, all hammer-action models are made weighted (see "Mechanics"), but among active keyboards this option is rare — due to complexity and high cost.

The presence of the aftertouch function in the keyboard (aftertouch). The essence of this function is to track the pressure force on the key after it is pressed. In fact, this means that in models with aftertouch, you can control the sound not only due to the force and speed of pressing the key, but also due to the change in pressure on it after pressing; this gives additional features and allows you to use various specific tricks of the game. The specific ways of changing the sound “tied” to aftertouch can be different, depending on the synthesis settings set: for example, when recording a guitar part, you can tie a small change in tone to this function and imitate string bending, when recording a saxophone, change the volume of notes, and etc.

Relatively inexpensive models use a common sensor to monitor aftertouch, which monitors the average force of pressure on all keys pressed; in more advanced ones, separate sensors are installed for each key.

The presence of a pitch controller in the keyboard (Pitch Bend).

This controller is usually in the form of a small wheel or lever that slightly changes the pitch of the sounding note. This allows you to use some specific playing techniques — for example, to imitate string tightening on a guitar.

The presence of the transposition function in the keyboard — switching the sound to a different key. When transposing, the pitch of all keys is simultaneously raised or lowered by a certain number of semitones. This function is useful in all cases when a melody learned in one key needs to be played in a different key — for example, if the original melody is too high or too low for the vocalist, if the external accompaniment differs in key, if you need to switch between keys during the song, and etc. In such situations, by transposing the sound, you can play a melody in a new key using the same familiar keys without relearning it.

The presence of an arpeggiator in the keyboard.

The name of this function comes from "arpeggio" — a technique for playing chords, in which notes are not played all at once, but in turn. Accordingly, the arpeggiator is a function that allows you to play a taken chord in the arpeggio technique: the musician presses all the keys at once, and the keyboard plays them in turn. This effect can also be achieved manually, but in some cases the arpeggiator turns out to be more convenient: it plays notes at a clearly defined speed and interval, can accompany them with various effects, and provides other additional features. These features vary depending on the model, but some instruments allow you to create entire songs with the arpeggiator by simply pressing a sequence of chords.

The maximum number of pedals that can be connected to the keyboard at the same time.

Pedals are used as additional controls to change various keyboard settings. The “classic of the genre” in this sense is the sustain pedal (see “Sustain”) — if the device has one connector for pedals, then this will almost certainly be the input for just such a pedal. Keyboards are produced, where there are 2 or more such inputs — in addition to sustain, you can connect pedals to them for other adjustments and effects (in particular, changing the volume).