OEM camera for
Car models for which this camera is standard.
Reversing cameras can be created both in the form of universal devices and for specific car brands. The key advantage of the second option is ease of installation: the camera is designed for a specific “seat” (like a boot handle, license plate light, etc. — see “Installation type”) and does not require special tricks for installation. Yes, and connecting the "eye" to the on-board network and the screen, usually, is also not a problem. At the same time, such devices are usually produced for one car model, at best — for 3-4 similar models; installation on a "non-native" machine is often even more difficult than mounting a universal camera. It is also worth noting that the choice of standard cameras for each particular machine is rather small — definitely less than the range of universal models. Therefore, there is a high probability that this type of camera, which is easy to install, will not be suitable for some of the parameters (for example, resolution).
Now on the market for such car brands, reversing cameras:
Audi,
BMW,
Chevrolet,
Chrysler,
Citroen,
Dodge,
Fiat,
Ford,
Honda,
...>Hyundai,
Jeep,
KIA,
Land Rover,
Lexus,
Mazda,
Mercedes-Benz,
Mitsubishi,
Nissan,
Opel,
Peugeot,
Porsche,
Renault,
Seat,
Skoda,
Subaru,
Suzuki,
SsangYong,
Toyota,
Volkswagen,
Volvo.
Video resolution
The resolution of the frame taken by the camera in video mode, in pixels — in other words, the size of the picture in dots horizontally (first digit) and vertically (second digit). It should be taken into account here that in the case of reversing cameras, the recording in pixels describes only the frame on the camera matrix itself; to describe the "picture" coming to the connected screen, the designation in television lines (TVL) is used. This is due to the fact that the video signal is transmitted in an analogue format; See Video Resolution below for more on all of this. Here we note that with the same resolution in TVL and the same viewing angles, a camera with a higher resolution in pixels will produce a clearer, more detailed image. But
HD reversing cameras, and even more so
Full HD units.
Сolour encoding system
The colour system refers to the format in which colour information is transmitted in an analogue video signal. In modern reversing cameras, the European PAL system or the American NTSC are most often used. It makes no sense to describe them in detail — suffice it to say that for the normal operation of the camera you need a radio tape recorder (or other device with a screen on which the image is displayed) with support for the same colour system. However, incompatibility in this parameter is not fatal — with such a connection, the image will only turn from colour to black and white (in extreme cases, its overall quality will slightly deteriorate).
Signal-to-noise ratio
This parameter describes the total amount of interference in the video output from the camera. The higher the signal-to-noise ratio (that is, the ratio of the useful signal level to the level of extraneous interference) — the better the image will be, the less distortion it will have. The minimum level for modern cameras is considered to be 40 dB — with it, the “picture” is reproduced with minor noise that does not significantly affect its perception. And in the most advanced models, this figure can reach 48 – 50 dB — such an image for the human eye is almost indistinguishable from the perfect one.
Of course, in fact, the quality of the image also depends on the capabilities of the screen on which it is displayed, however, even the best screen will not save a “noisy” camera.
