1stPlayer H5-R1 black
 | Outdated Product This model is primarily distinguished by a spacious chassis, good cooling and a stylish exterior design. So, the device is equipped with a built-in RGB backlight and a translucent tempered glass sidewall. The system unit is built in the form factor of a mid-sized tower (Midi Tower). The chassis will fit an ATX motherboard, but you can install any of its junior derivatives. The 1stPlayer H5-R1 system unit allows you to use powerful computer hardware. Inside the system unit there is a place for a graphics adapter 360 mm long, the height of the processor cooling is 175 mm. A hard drive rack is also mounted inside the case, designed for two 3.5" drives and one 2.5" drive. For the power supply has a separate compartment at the base. 4 standard fans with a diameter of 120 mm are responsible for...cooling. One cooler is installed at the back, three — on the front panel. To improve the already good blowing system, you can install an additional 4 impellers, two at the bottom and two at the top. The case is built on a solid frame, the sheet metal does not flex easily, and the built-in RGB lighting does not need a controller, as it connects directly to the power supply, which uses a standard Molex connector. |
 |
This model is primarily distinguished by a spacious chassis, good cooling and a stylish exterior design. So, the device is equipped with a built-in RGB backlight and a translucent tempered glass sidewall. The system unit is built in the form factor of a mid-sized tower (Midi Tower). The chassis will fit an ATX motherboard, but you can install any of its junior derivatives. The 1stPlayer H5-R1 system unit allows you to use powerful computer hardware.
Inside the system unit there is a place for a graphics adapter 360 mm long, the height of the processor cooling is 175 mm. A hard drive rack is also mounted inside the case, designed for two 3.5" drives and one 2.5" drive. For the power supply has a separate compartment at the base. 4 standard fans with a diameter of 120 mm are responsible for cooling. One cooler is installed at the back, three — on the front panel. To improve the already good blowing system, you can install an additional 4 impellers, two at the bottom and two at the top. The case is built on a solid frame, the sheet metal does not flex easily, and the built-in RGB lighting does not need a controller, as it connects directly to the power supply, which uses a standard Molex connector.
