Catalog   /   Climate, Heating, Water Heating   /   Water Supply & Pumps   /   Water Heaters   /   Electrolux

Electrolux EWH 120 SL

Photos - Boiler Electrolux EWH 120 SL
Outdated Product
Type: storage; Energy source: mains; Tank volume (L): 120; Power source: 230 V; Power consumption (W): 1800; Magnesium anode; Heating elements: 2; dry heater; thermostat; overheat protection; safety valve; Pipe connection: installation dependent; Dimensions (cm): 105x48.9x51.6;
add to listmy lists
Electrolux EWH 120 SL
Main
Typestorage
Energy sourcemains
Installationuniversal (wall)
Tank volume120 L
Tank shaperectangular
Technical specs
Power source230 V
Power consumption1800 W
Max. water temperature70 °C
Tank liningenamel
Water supplywith pressure
Heating time240 min
Magnesium anode
Heating elements2
Heating element typedry heater
Features
Functionsthermostat
Safety systemsoverheat protection
safety valve
General specs
Controlsmechanical
Controls layoutfront
Pipe connectioninstallation dependent
Dimensions (HxWxD)105x48.9x51.6 cm / Weight — 40 kg /
Added to E-CatalogJune 2006
The information in the model description is for reference purposes.
Always clarify the specifications and configuration of the product with the online store manager before purchasing.
Catalog Electrolux 2026 - new arrivals, bestsellers, and the most relevant models Electrolux.
1
2
4
13
See comment
15 June 2012 
I used an Electrolux 180-liter water heater for about 10 years. I mainly turned it on during the summer. In winter, I tried to drain the water, but I didn't always do it. I don't remember the model, but the exterior looked like this one. There were no problems, except for some inconvenience during draining. The tank was enameled. When I bought it, I noticed that the warranty was only 1 year. The sellers told me that the anode needed to be replaced often. I never replaced it. Periodically, once every one or two years after draining the water, I would unscrew the nuts, remove the bottom cover, wipe the tank inside as far as I could reach with my hand, and check the condition of the enamel and the anode. There was some rusty substance on the seams. After wiping, I saw a few "spiders" in the seams (using a flashlight). The anode was visibly corroded, but not very deeply. Since there was still a lot of magnesium left in the anode (after 10 years, at least half remained), I concluded that mandatory anode replacement was unnecessary. At least, for our water (St. Petersburg). The heating elements seemed to be covered with glass. Apparently, these are called dry. They still look like new. I would have continued using the device, but after renovations in the bathroom, the water heater no longer fit my space requirements. I gave it to my daughter. Now I'm looking for another one, around 100 liters, which is why I joined this discussion. Apparently, I will get the best one regardless of the price. I don't know how good the modern models are, but that one was definitely good.
See comment
See comment
Andreyuse Electrolux EWH 100 SL more than year
normal device
19 October 2010 
be careful with the adapters that come with the kit. They are plastic. One burst during installation.
I bought it and installed it, so far so good. Be sure to install an additional drain valve. The valve that comes with the water drain kit is tin.
not yet.
kto touse Electrolux EWH 100 SL week
The price matches the quality
24 April 2012 
-
Cheap, efficient, does its job
For some reason, the automatic system is triggered when it's set to maximum heating. In winter, when the water in the pipes is close to freezing, it somehow starts turning off. I have to take it apart and switch the "automatic" setting.
Maxim Chudovuse Electrolux EWH SL more than year
3 out of 20 user review(s) shown
10 more user review(s)
Additional features water heater Electrolux EWH 120 SL:
  • White colour
  • Tank material — steel with glass-ceramic coating
Additional information:
  • Two modes of heating power, which allows to reduce energy consumption and load on the power grid
  • Thermostat on the front panel
  • Separate heating elements not in direct contact with water
  • Thermal fuse against overheating
  • The internal capacity of the tank is made of steel (thickness 1.8 mm) and covered with a layer of fine glass enamel