Vityas KG-3200

The handle attachment breaks immediately if there is just a little more load. I recommend finding a higher quality one right away. It is not expensive. Replace it. I recommend mowing with an 8-blade hay cutting disc, which is easy to restore. Or a diamond saw blade with 40 teeth. The normal line overheats the engine in dense grass. The disc works without overheating. Take a break every 15 minutes. I have 75 sotkas. Mowed with different discs. In two approaches (two days of 4 hours each) in one stage. It takes 5 hours. There were very dense thickets with sticky weeds wrapping around each meter high. Everything was tangled. Everything was mowed down. While working, I recommend touching the air outlet from the engine by hand, as it can overheat. I have experience with the Grand 2700. Also good, but the same disadvantages. However, it also had a weak assembly connection of the split rod. I replaced it. This Grand broke the body attachment to the rod which I redesigned. Also, both the anchor and the stator burned out. Replacing the anchor and stator plus brushes cost 850 hryvnias. The warranty on the previous one expired, so the official representative sent the spare parts within a week (4 days). I also recommend checking the condition of the brushes, as they also affect overheating when worn. (So they don't wear out completely unnoticed and short circuit the wires to the anchor.) With my 75 sotkas, replacing the brushes after each full mowing for safety. If the grass is low, the work is easier. There is no overheating with the line. I recommend a thin but high-quality one. Expensive. Reduces load. But still with a disc! (VSB--8T, or VSB--40T) This 3-blade disc in the photo, I do not recommend using.